Zero Outflow of Defects


Equipped with complete 5D (3D&2D) illumination mechanism

  • 4-directional projector (3D)

Equipped with an illumination mechanism that can project a striped image infinitely close to a sine wave. The Z range of -5 to +20 mm can be measured at a resolution of 1 µm. Minimized variation to 3σ ±5 micron (data taken using our evaluation PCB).

  • Large 2-stage illumination (2D)

Upper-stage episcopic illumination (R) and lower-stage circular illumination (RGB) of 300 mm in diameter. Greatly improves performance of character check etc. with versatile illumination control.

Top of page


Omnidirectional imaging with vertical and 4-directional oblique cameras

  • 25 mega pixel top camera

Equipped with aseismatic telecentric lens of 125 mm in diameter, securing the industry’s largest level of 69 mm x 69 mm viewing angle.

  • 4-directional oblique camera (optional)

Reliably captures and inspects locations that cannot be captured by the vertical camera, such as leads hidden in the lip of a connector.

Top of page


Enhanced fillet determination expression

Widely applicable from securing inspection quality in a short time to high-accuracy defect detection, combining three determination modes
Combination of three determination modes provides a wide range of applications, from securing inspection quality in a short time to high-accuracy defect detection.

  • Free setting method

Detects defects based on one or multiple factors of manufacturer’s default settings.

  • SJ judge method

Set based on the trend of factors’ evaluation values obtained from OK samples. Determined as defective when the value deviates from the good product trend range.

  • Determination analysis method

Let the inspection equipment learn OK/NG samples to extract factors that allow OK/NG separation appropriately. OK or NG is determined based on the combination of these factors. (Multivariate analysis)

What is multivariate analysis?

Top of page


Contact